About 2,280 results
Open links in new tab
  1. Question: What fluid should be used in a T-56 transmission in a 1994 ...

    Answer by John Donato: The original factory fluid fill for the 1992 to 1995 T-56 used in the Viper was Dexron III ATF. In 1996 with the introduction of the Viper GTS the fluid was changed to Castrol …

  2. Transmission Syncro adjustment – Drive Viper

    Jun 11, 2025 · Access if from the top – inside the car. Remove cigarette lighter/radio/ashtray bezel, remove the shift knob, remove the center console, finally the lower (rubber) shift boot. If you do not …

  3. Video 2000 WHP Gen V Viper ACR e 6 speed manual – Drive Viper

    Jun 11, 2025 · Internally, the gearset would look similar to a sequential transmission design being a dog tooth engagement gear system. But the shift mechanism is entirely different, which is where the term …

  4. Gen IV Transmission Fluid Change – Drive Viper

    Jun 11, 2025 · Just changed transmission fluid in my new tranny. Only 800 miles on it but I figured it should be done before CoTA. The DRILL PUMP with garden hose thread X 3/8″ hose barbs with …

  5. Looking for Transmission Lower dust cover – Drive Viper

    Jun 11, 2025 · Hi all, I was under my Comp Coupe getting ready for the Viper Showdown in Indy in a couple weeks. Discovered that that one of the mounting ears on the dust cover had broken. These …

  6. Gen III Manual Transmission Fluid Change – Drive Viper

    Jun 11, 2025 · 2005-Viper-Fill-Plug-Transmission.jpg 2005-Transmission-Drain-Plug.jpg Amsoil-1.jpg Amsoil-2.jpg I changed the Manual Transmission Fluid on my 2005. First time using AMSOIL …

  7. 1600 WHP Gen V Viper sequential testing on dyno – Drive Viper

    Jun 11, 2025 · This is a Delta Series twin turbo system with a full engine build and all the driveline supporting modifications to match including a sequential gearbox, making repeated 1610-1620 WHP …

  8. Page 44 – Drive Viper

    Jun 6, 2014 · Allow the transmission fluid to drain (I didn’t do a good job guessing where to put the drain pan). Install the drain plug using the PTFE tape into the tail housing (torque to 28 ft lbs). Use the …

  9. Topic: DSE Transmission Crossmember and Polyurethane Mount Kit

    Jun 11, 2025 · Now available, an aluminum crossmember that is 0.7 lbs lighter and stiffer than the OEM steel version and an adapter kit for a polyurethane transmission mount. Thanks Doug IMG_0620 …

  10. Transmission noise after warm up – Drive Viper

    Jun 11, 2025 · So I installed a used transmission and filled it with Royal Purple ATF Max. Its a 2001 trans. Everything sounds good in the trans until I drive it about 30 miles or so. After the transmission …